SECTION 2
4405-0308
4405-0309
4405-0310
PERFORMANCE SERIES 360W
FAIRING/REAR SPEAKER AMPLIFIER KITS
  • 7 1 / 4 ” round drivers are the largest diameter speakers that can be installed into
  • the Harley ® Road Glide style fairing, with cone volume and mass comparable to a 6” x 9” speaker
  • 5 1 / 4 ” round drivers are the largest and most efficient speakers you can install into the rear speaker
  • pod position on the Harley Road Glide Ultra
  • Two-speaker kits include: two speakers, custom-made plug-n-play wiring harness, top quality
  • heavy gauge power/ground wires, all necessary mounting hardware, complete installation/operation instructions and 180w RMS 2-CH amplifier
  • Four-speaker kits include: four speakers, custom-made plug-n-play wiring harness, top quality heavy gauge power/ground wires, mounting
  • hardware, installation/operation instructions and 360w RMS 4-CH amplifier
  • Six-speaker kits include: six speakers, custom-made plug-n-play wiring harness, top quality heavy gauge power/ground wires, mounting
  • hardware, installation/operation instructions and 360w RMS amplifier
  • At 2 ohms impedance and 140/120+ watts max power, these speakers provide the ultimate in bass response, extended mid/high frequency range FENDERS
  • and raw audio power
  • Feature a waterproof injection-molded polycarbonate woofer cone, high-flux strength but lightweight, dual-donut Neodymium magnet,
  • high-efficiency voice coil, the latest design grillework with mounted tweeter and mid-range and top-quality adapter rings/bracket hardware for
    secure and clean mounting into the Road Glide Ultra
  • The most efficient speakers you can buy for your Harley, and their mounting hole pattern and spade electrical connections are exactly the same
  • as the factory specification
  • Full-range class D amplifier at 90W RMS per channel x 4 channels; 360W total, driven into a 2 ohm load at 14.4 VDC
  • Amplifier gain adjustments are factory preset for two-, four- or six-speaker configuration on the Harley Road Glide Ultra
  • Amps mount inside the fairing using the custom-made stainless steel bracket system
  • Include custom-made plug-n-play wiring harnesses, all necessary mounting hardware and installation/operation instructions
  • Amplifier measures 7 1 / 4 ” L x 4 3 / 4 ” W x 1 3 / 4 ” T
  • P ART  #
    DESCRIPTION
    SUG. RETAIL P ART  #
    DESCRIPTION
    SUG. RETAIL
    FOR 11-13 FLTRU
    FOR 06-13 FLHTCU
    4405-0309
    4-speaker
    $899.95 4405-0308
    6-speaker
    $1,349.95 COVERS &
    4405-0310
    4-speaker
    899.95 GENERAL
    79