SECTION 7
HIGH PERFORMANCE OIL PUMPS
0932-0088
  • Helps to reduce oil carryover during high rpm operation; higher
  • volume helps reduce engine and oil temperatures
  • 53mm diameter rotors for maximum performance
  • Gain of 20% oil pressure, 125% pressure volume and 135% scavenge
  • 0932-0087
    volume over OEM stock TC88 oil pumps
  • Gain of 16% oil pressure, 66% pressure volume and 100% scavenge
  • volume over OEM stock TC96/ 103 oil pumps
  • High-quality die-cast aluminum body construction, high-strength steel
  • gear construction
  • Fits both stock and aftermarket cam support plates for
  • seamless installation
    PART #
    DESCRIPTION
    SUG. RETAIL PART #
    DESCRIPTION
    SUG. RETAIL
    0932-0088
    For 07-17 Twin Cam and 06 Dyna models
    $149.95 0932-0087
    For all 99-06 Twin Cam (except 06 Dyna models)
    $149.95
    OIL PUMP ASSEMBLY
  • High-quality replacement cast aluminum
  • pump body with steel gears and shaft
  • Raw cast aluminum finish
  • PART #
    DESCRIPTION
    SUG. RETAIL CONTROLS
  • Gaskets and seals included
  • 0932-0189
    For 86-18 XL
    $169.95 & MIRRORS
    RACE SERIES ® OIL PUMP FOR M-EIGHT
  • Precision-machined pressure relief valve and bore
  • Every pump is bench tested, the relief valve is seated and sealed to a
  • minimum of 30 psi with full pop off at 55-60 psi
  • Increased oil volume from the larger gears and properly sized passages along with the pressure
  • relief valve seat and seal from these oil pumps is essential for proper oiling system function
  • Eliminate common pressure and scavenge issues associated with the factory oil pumps
  • When matched to a Feuling camplate, pumps reduce engine and oil temperatures, increase oil pressure volume,
  • and scavenge volume on the return side to reduce build up of oil in the crankcase
  • Increase oil flow in and out of the engine with corrected tolerances, oil passages and larger geroter gears
  • High-flow 2.250” Chrome Moly gerotor gears
  • 20% more pressure and 20% more scavenge volume over stock
  • Magnet to help protect gears and pressure relief valve
  • Billet 7075 aluminum construction with red anodize, 7075 material holds tighter tolerance under temperature
  • Increased scavenge port holes and galleys requiring them to be matched up to a Feuling High Flow camplate
  • Increases oil pressure
  • Increased kidney passage volume
  • Eliminates blowby and wet sumping
  • Cooler oil and engine temperatures
  • More horsepower and torque to the rear wheel
  • Made in the U.S.A.
  • P ART  #
    DESCRIPTION
    SUG. RETAIL
    NOTE: Must be matched to a Feuling High Flow camplate.
    0932-0196
    For 17-18 M-Eight
    $499.95 HARDWARE,
    DISCLAIMER: NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES.
    SEE PAGE 396 FOR IMPORTANT EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND WARRANTY INFORMATION.
    735