7-SPEED TRANSMISSION GEAR SET
EXHAUST •The 7th gear enables the motorcycle to make full use, by way of gear ratio management, of the torque
Direct replacement of the Cruise Drive Harley-Davidson factory 6-speed
and power put out by the 96 ci, 103 ci and 110 ci motors
Unlike the stock mainshaft which includes 1st through 4th gears, the DD7 is lightweight and only includes
FUEL/AIR the small 1st gear, minimizing the shift clunk
Features a shortened 1st gear and tightened all other gears for a smooth and powerful riding experience
with continuous acceleration from 1st to 4th gear
Shift smoothness is achieved by use of a new linear roller ball detent which is part of the supplied billet
ENGINE •Comes ready to slide in the bike, no case modifications, shimming of the gear set or adjustments required
7th main drive gear, main drive gear bearing, main drive seal are all included to replace 6th main
ARP 12pt bolts for door, top cover, stock side cover, Baker re-cal box and leads all included
Reuses stock shifter pawl
Utilizes F6F door bearing retainer plate
DD7 door bearings are 28% wider than stock
GASKETS •Made in the U.S.A.
& SEALS P ART #
For 07-16 FLHT/ FLHR/ FLHX/ FLTR, 07-16 FXST/ FLST, 06-16 FXD/ FXDWG
6-SPEED OVERDRIVE SUPER KITS
Designed to turn stock 5-speed transmission into
Reduces vibration that creates wear
Creates a more relaxing cruising speed
All gear sets use 2.94:1 close-ratio 1st gear that widens
FENDERS bike’s speed range in 1st gear and lessens the rpm drop
Overdrive 6th gear (.86:1 ratio) lowers engine rpm by
almost 475 at 75 mph
Made in the U.S.A.
kit (PART #2404-0114; see ELECTRICAL section); if
speedometer is not driven from transmission, then two block-off plates kits are required.
NOTE: Requires speedometer be recalibrated.
NOTE: Trap door extends 3 / 8 ” farther to right than stock part. Alteration to some parts that attach to or around the trap door may be required.
NOTE: When installing in 02-06 FLHT/FLHR/FLTR/FLHX transmission case, you will need an oil filler spout spacer (PART #DS-196233; see ELECTRICAL
section) for clearance transmission to motor vent line.
COVERS & 1103-0009
For 01-06 FLHT/ FLHR/ FLTR/ FLHX, 02-06 FXST/ FLST, 01-05 FXD/ FXDWG
For 00 FLHT/ FLHR/ FLTR, 00 FXST/ FLST, 99-00 FXD/ FXDWG