V-TWIN TOOLS
3807-0249
3807-0206
TWIN SCAN DIAGNOSTIC KITS
  • Communicates with ECM, TSSM and BCM to read, then clear diagnostic trouble codes
  • Activate ABS solenoids for proper brake bleeding and testing
  • Real time display of engine sensors along with built in data logging will store data for up to one hour
  • Data logging automatically trigged when a trouble code is set and shows the data before and after
  • Analog inputs can also be used for air/ flow ratio (AFR)
  • Easy to navigate software
  • Requires use of a PC with Windows 7, Windows 8 or Windows 10 for display
  • Use probe kit PART #3807-0189 to use scopemeter function; includes two insulation-piercing probes
  • Made in the U.S.A.
  • NOTE: Models equipped with 12mm oxygen sensors will require 18mm weld nuts be installed in the exhaust
    system for use with the Twin Scan 3+ kit 18mm oxygen sensors.
    3807-0189
    DESCRIPTION
    SUG. RETAIL
    For 11-16 models w/ CAN data Bus
    $464.00
    3807-0249
    For 01-13 models including V-Rod and 08-13 touring models w/ 36-pin Delph fuel-injection system
    (except 11-13 Softail and 12-13 Dyna models) and 03-06 carbureted models w/ 12-pin module
    464.00
    3807-0189
    Twin Scan 3 Probe Kit
    94.00
    WEGO III WIDE-BAND AFR
    (AIR/ FUEL/ RATIO) MONITORING TOOL
    and dyno tuning
  • Highly accurate with less than +/- 0.10 AFR error over 10.3-19.5 AFR range using Bosch LSU
  • 4.2 5 wire wide band oxygen sensor(s)
  • Easy free air calibration procedure corrects for effects created due to sensor aging
  • to all leading dyno systems
  • Waterproof with ultra-bright daylight readable blue display features automatic dimming function
  • 11-16V DC supply voltage needed for operation; current drain is approximately 1  amp
  • Built in USB interface
  • Data logging software needs a PC or laptop with Windows 7/8/10; data can also be exported to an Excel spreadsheet for further analysis
  • mounting and software
  • Use PART #1022-0008 for replacement Bosch O 2 sensor (sold each)
  • P ART  #
    DESCRIPTION
    SUG. RETAIL
    P ART  #
    DESCRIPTION
    SUG. RETAIL
  • Made in the U.S.A.
  • 1022-0054
    Single channel
    $452.00
    1022-0110
    Dual channel
    $622.00
    O 2 BUNG INSTALLATION KIT
  • Remove heat shields, install bung and tune; when completed, use included
  • screw and copper washer to seal bung and then replace heat shield for
    unaltered finish
  • No pump or sampling tube required and allows both cylinders to easily be
  • monitored at the same time
  • Bung installation kit includes one hydraulic insertion tool, one drill bit,
  • two O 2 sampler blocks, tubing, 25 Rivnuts, 25 screws and 25 copper washers,
    all contained in plastic case
  • Refill kit PART #3807-0378 includes 25 each of bungs, plugs and copper
  • washers, sold separately
    3807-0378
    DESCRIPTION
    P ART  #
    SUG. RETAIL
    DESCRIPTION
    P ART  #
    SUG. RETAIL
    O 2 bung installation kit
    3807-0378
    $594.95
    Refill kit
    3807-0398
    $55.95